Imperial Civil War [Empire at War] > Imperial Civil War Tech Support
Imperial Civil War 2.0 Startup Troubleshooting
Corey:
If your mod crashes on startup, these are the most likely causes.
1. Make sure you completely remove 1.3 before installing 2.0. Do not install 2.0 directly over 1.3.
Just please, don't do it.
2. Make sure you have the Forces of Corruption RAM fix.
This can be found here: http://help.starwars.com/articles/en_US/FAQ/Star-Wars-Game-Update-and-Patch-list?section=Star-Wars
This can be found here: http://www.lucasarts.com/support/update/EAWFOC1_1.html#fix
The file you're looking for is called FOC_RAM_MPLobby_update.exe
3. Make sure no other mods are installed into data.
You can have as many mods as you want in your mods folder, but if you have one hard installed overwriting the main Forces of Corruption data folder, it will cause a crash.
4. Make sure you're giving it enough time to load.
Unless you actually get an exception error, chances are you're just not giving the mod enough time to load. The mod is quite large, so it can take a few minutes to startup, especially on older machines.
If you've tried all of these, and still have problems, respond to this thread and I will try to help you.
KierenHorn:
It would seem I just can't get the game to start. I load up the game, the initial image shows and then it just crashes to desktop. :(
Corey:
Do you get any error messages or does it just go from the Stormtrooper shoulder to desktop without the exception notice or anything?
KierenHorn:
It says the program has stopped responding. It never finds a reason why though.
earl:
Well here is what i am getting i don't even get it to load :'(
Navigation
[0] Message Index
[#] Next page
Go to full version